Charge the sonic brush

1. Before first use, charge the sonic brush for 16 continuous hours.

2. Hold brush head by the rim and press over mounting post on handle until it snaps firmly into place.

3. Wet your skin and apply your favorite non-granular liquid cleanser to skin or brush.

4. Turn brush on and select speed setting by pressing the on off button once for HIGH, twice for Medium, and three times for Low. We recommend starting on Low to see how your skin reacts.

Wet your skin

5. Keep the oscillating brush in light contact with your skin. Do not press hard. Move the brush in a slow circular motion flush against your skin.

6. The 60-second automatic cleansing cycle is punctuated by a beep every 10 seconds. When the beep sounds, move the brush to a different section of skin to be sure that every area receives equal attention. If desired, change speed setting by pressing the on off button.

7. The brush automatically stops after 60 seconds, but you can stop it at any time by pressing the on off button for one second.

Speed Settings

8. When cleansing is done, rinse your skin with water and towel dry.

9. Store your brush with the protective brush cover on and remember to clean your in-use brush heads once a week with a mild solution of warm, soapy water.

10. Replace brush heads after three months of use. To remove a brush head, hold it by the rim and pull off.

For more information, please download the instruction from our official site.

Facial cleansing zones

Move the brush in a slow circular motion around your face. Let the sonic oscillation do the cleansing.

Note: Do not apply treatment close to the eyes to avoid risk of injury.

10 seconds at each location.

1 cycle 60 seconds.

Special Cautions For Delicate Areas

The true glow sonic facial brush is a face and body cleansing device that is intended to help you get clean and healthy-looking skin. The true glow sonic facial brush is not a medical device and is not intended to be used to treat any medical conditions such as acne.

If you are under a doctor's care for any skin condition or if you think you have very sensitive skin, please consult your physician before use.

We recommend starting on the low setting and slowly increasing speed depending on how your skin reacts to treatment. If rash or irritation occurs, stop use.

We recommend not sharing the brush heads each user should have their own brush head.

Do not use with exfoliation creams with rough or jagged particles.

Removing makeup can cause the brush head to discolor. This will not affect performance and the brush head can be used for the entire recommended life of 90 days.

If you experience any pain or discomfort during use, stop using and consult your physician.

Moisten your face and apply cleanser. Also apply a small amount of cleanser to the moistened brush head. Do not apply pressure with the brush to the face let the sonic oscillation perform the cleansing. When finished, rinse with water and dry skin with a clean towel.

Three Speed Options

The three speeds available on your true glow sonic facial brush allow you to customize your facial cleaning routine to suit your individual needs.

True Glow Sonic Facial Brush Features

Attachments

Normal skin: white bristles with a white plastic back.

Sensitive skin: white bristles with a light grey plastic back.

Body: larger brush size with white bristles and darker grey plastic back.

Timer: timer allows consistent treatment in each of the 6 facial cleansing zones (see diagram) with a beep after 10 seconds of treatment. The unit also safely shuts off in 60 seconds.

Waterproof: the true glow sonic facial brush is waterproof and can be used in the shower.

Rechargeable: the true glow sonic facial brush is cordless and requires a full charge before use. After unit is fully charged, it can provide up to 35 minutes of use without recharging.

Charging the sonic facial brush

1. Before using the sonic facial brush for the first time, it must be fully charged for 16 hours. Plug the power adapter into a wall outlet and plug the dc jack into the back of the charger base. Place the sonic cleaning brush into the base and be sure the red led lights, indicating that the unit is charging.

2. The charging indicator under the control panel will illuminate red during charging. Once fully charged, the light will illuminate green. Always check to ensure that the charging light illuminates when you place the sonic facial brush in the charging stand.

3. The red light will start flashing when the unit reaches low battery capacity during operation.

Features (Cont)

4. The adapter may become warm while charging this is normal operation.

5. In order to maintain the optimum capacity of the rechargeable batteries, the sonic facial brush should be given a full 14-hour continuous charge every 3 months.

6. Unplug the adapter from the wall and the base when not in use. Do not unplug the adapter from the wall when it is still connected to the unit. This will cause the battery to discharge

Start ing the sonic facial brush and selecting the speeds

Press the on off button 1 time for high setting, 2 times for medium setting and 3 times for low setting. The speed setting will illuminate, indicating the setting on the control panel.

Automatic 6-zone cleaning cycle

Once the sonic brush is started, it will beep every 10 seconds to change the position on your face. It will shut off at 60 seconds after completing the cycle. You can change speeds during the cycle by pressing the on off button until you get to desired setting.

Stopping the sonic facial brush

At any time the sonic brush can be stopped by pressing and holding the on off button for 1 second.

Attaching and removing your brush head

To attach the brush, hold the brush by the rim and press over mounting post until it firmly snaps into place. To remove, hold the rim and pull off.

User Maintenance Instructions

Caring for your true glow sonic facial brush

1. After each use, wipe the brush handle with a damp cloth to remove any oils or lotions used during treatment. Be sure you keep the charging contacts on the sonic bush clean to keep the unit charging properly.

2. Once a week unplug the dc jack and clean the charger base to prevent buildup of oils and lotions. The 2 pin contacts must be clean for the unit to charge properly.

3. Clean unit thoroughly each week by rinsing under warm soapy water to help remove oil and lotion buildup, wipe with a dry cloth and store unit in its box or in a clean, dry place.

4. Remove brush heads once a week and rinse under warm soapy water to remove residue accumulated during treatment. Allow brush heads to air dry. Store in a clean, dry place.

5. Do not use abrasive cleaners for cleaning.

6. Do not put unit in dishwasher for cleaning.

7. When storing the brush off the unit, use the protective cover. This will prevent the bristles from deforming.

Note: it is recommended to replace the brush attachments every 90 days, as the bristles wear over time and lose their efficacy.