Water floss in the shower!!

Using the H2Oral Irrigator in the shower eliminates many of the unpleasant issues often associated with oral irrigators and water flossers.

• No cluttered counter space
• No messy sink and mirror to clean
• No setup and storage between uses
• Non-electric, it uses the water pressure from the shower.
• Water temperature and pressure are easily adjusted to your personal comfort level.

Dentist Recommended - Proactive Dental Care

Despite good brushing habits, food particles and bacteria (plaque) can accumulate in pockets below the gum line and around dental work such a braces, bridges, and implants. This is what hygienists scrape away during regular checkups and cleanings. Dentists know that if left untreated, this accumulation of plaque can lead to gingivitis; (inflammation, excessive bleeding and bone loss).

The H2Oral Irrigator effectively directs water flow into hard-to-reach areas of the mouth, disrupting and flushing away bacteria and food particles from areas where conventional flossing methods may be awkward and less effective.

Installation Instructions

1. Remove shower-head from shower pipe.
2. Wrap male threads of shower pipe and Adapter with teflon tape to seal the threads and prevent leaks.
3. Align and thread adapter onto shower pipe.
4. Install shower-head onto Adapter.

Important notes:

• Failure to use teflon tape on threads may result in leaking.
• Improper alignment of threads when installing may damage the threads.
• Contact the manufacturer for technical support.

Pic Installation

To properly install your personal Pic:

• Align the locating tabs on the base of the Pic with the slots in the Housing, insert the base of the Pic into the Housing and rotate it to the locked position. This will lock the locating tabs of the Pic into the slots of the Housing and prevent the Pic from coming out.
• To remove the Pic from the Housing, rotate it in the opposite direction, to the unlocked position, and pull it out.

When installed correctly, the Pic is not able to "pop out" during use.

Waterflow vs a typical 2.5 gpm shower head (gallons per minute)

The water flow from a standard 2.5 gpm shower head will not be reduced by installing the H2Oral Irrigator Adapter.

• Residential water pressure typically ranges between 40-80 psi (pounds/square inch). Using the standard converting formula of PSI to GPM, we know the H2Oral Irrigators orifice diameter of 0.190", with a low-end residential water pressure of 40 psi, will have a flow rate of approximately 5.4 gpm.
• If the water pressure in your home is only 20 psi (which is considered very low, and under the minimum water pressure required by most building codes) the water flow through the H2Oral Irrigator Adapter would still be approximately 2.479 gpm, comparable to the flow of a standard 2.5 gpm shower head.

Fresher Breath

Everyone has experienced "morning breath". It is the result of bacteria that builds up in your mouth while you sleep.

The H2Oral Irrigator reaches into areas your toothbrush can't. It disrupts, dilutes and flushes away the bacteria that cause bad breath, leaving your mouth feeling cleaner and fresher than brushing alone.

Effective - Affordable - Convenient to Use

• Cleaner Teeth
• Healthier Gums
• Fresher Breath

Who wouldn't want that?

Made in U.S.A.

Small business keeps America growing!!