Important: Read and follow enclosed instructions carefully before using this product.
1. Clean Area
Thoroughly clean the area to be treated using a Nad's Cleansing Wipe or non-moisturizing soap. Ensure all oils, makeup and moisturizers are removed and then wipe skin completely dry. For extra foaming, moisten Nad's Cleansing Wipe with water.
2. Apply Nad's Facial Wand
Remove the wand cap and slowly twist the end until gel appears at wand tip. N.B. it is important to twist slowly to minimize pressure build up. When first used, this may take up to 20 twists. Slowly apply a thin layer of gel in the direction of hair growth. Hair should be at least 3 to 5mm or 1/8 to 1/5 inches long. On areas such as the upper-lip hair can grow in different directions. Always assess carefully before applying the gel. Nad's Facial Wand Eyebrow Shaper is best used at normal body and room temperature (room: 22ºC/72ºF). But when it is cold or if the gel is too thick, briskly rub wand between hands for 20 to 30 seconds. Alternatively, place wand in a cup of hot tap water for 2 minutes, tip facing upwards, water level no higher than the (R) symbol. Ensure water does not come into contact with the gel as this will cause the gel to become ineffective. Only apply the gel over the hair you wish to remove. Any excess will wash away with warm water.
3. Apply Cotton Strip
Immediately place strip over the gel. Using your index finger, firmly smooth over the strip 3 to 4 times in the direction of hair growth. Nad's Cotton Strips can be washed and reused.
4. Remove Gel
Holding skin taut with one hand, quickly pull strip off in the opposite direction of hair growth. The quicker you pull the strip the more effective the hair removal. Remember to hold skin taut with the other hand and to pull close and parallel to the skin rather than away from the skin. If any gel residue is left on skin, simply rinse away with warm water.