Switch between Fahrenheit or Celsius

You can alter how the temperature is recorded by switching between temperature in Fahrenheit or Celsius.

To do this, go into power off mode, press and hold the START button then press the STAND-BY (ON/MEM) button for 3 seconds. °C will switch to °F. You can use the same process to switch back from °F to °C.

Note: when you switch between °C and °F the memory will be cleared

Measure Surface Temperature

You can measure the surface temperature of any object, such as water, milk, cloth or skin, using the infrared mode.

To do this, turn the thermometer on, then press and hold the Stand-By (On/MEM) button, and START button at the same time.

You will get the real time temperature immediately and it will be continuously updated as you hold the Start button.

Tips for Taking an Accurate Reading

- Patient must be inside for 30 minutes before taking a measurement.

- The patient and device must be in the same stable ambient (room) temperature for 15 minutes before operating.

- Always make sure the scanner lens is clean and undamaged.

- If the eyebrow area is covered with hair, sweat, make-up or dirt, please clean the area beforehand to improve reading accuracy.

- Patients should not drink, eat or be physically active before / while taking the measurement. - Remove hats and wait 10 minutes before taking a measurement.

- Always hold the thermometer and forehead steady when taking a reading. Do not move the thermometer until you hear the final beep.

- Don’t take a measurement during or immediately after nursing a baby.